Islamic bindings – instructions part 1

These instructions are to coincide with the Islamic binding lessons that we have been having with Kristine Rose from the Fitzwilliam Museum.

Sewing and spine preparation

The two sewing stations must be prepared in advance of sewing as the paper is not good enough quality to work blind on the book, this can be done by piercing the paper or by scoring the stations with a knife. Commonly sewing was in yellow silk.

Islamic Binding Sewing two stations
Sewing two stations

Sew the first two sections twice as it is not initially sewn off, then continue to sew using link stitches. For sewing off, make the final stitch a kettle stitch, so that it is secured.

Knock sections up between boards and put into a laying press.

Stipple a small amount of paste into the sections to stick initially, then repaste with stippling and put spine lining on and bone folder down. The spine lining should be an evenweave linen, commonly mauve was used.

Islamic Binding Pasting up the spine
Pasting up the spine

Excess linen is to be trimmed and pasted to the book block. This will be hidden by the board attachments. The linen should only be a couple of millimetres either side of the spine.

Islamic Binding lining the spine
Lining the spine

Endbands:

End band cores should be the same material as covering, cut 3mm and just wider than the text block, these are to be glued up on the flesh side of the leather and moulded so that no fibres stick out. The cores should then be stuck onto the spine, adjacent to the spine and just hanging over either side.

Each section centre should then be marked.

Islamic Binding The end band core
The end band core

Sewing of the endbands is done using three threads:

Primary thread – this should be a bright colour, often a gold, so that it can be seen in contrast to the other two. This is sewn through every section and over the cores, which creates the basis for the second two threads.

Islamic Binding Working the primary
Working the primary
Islamic Binding working the first two rows
working the first two rows

Secondary thread – this is woven over and under the primary thread at the middle of the core and left at the other end

Islamic Binding Locking the secondary with the tertiary
Locking the secondary with the tertiary

Tertiary thread – this follows the secondary thread on each row, going ‘under the overs’ and ‘over the unders’ meaning that every time a secondary thread goes over the primary, the tertiary will go under both, and when a secondary thread goes under a primary, the tertiary goes over both.

Islamic Binding Starting the tertiary
Starting the tertiary

The tertiary then anchors the secondary at the other end, allowing the secondary to weave back through the primaries to the starting point. Once the tertiary has come back and two rows are complete, there should be a chevron pattern starting. These two rows are then shuffled along the primaries to sit on the text block, before the next row is started.

Islamic Binding Chevron
Shuffling the chevron down the primary
Islamic Headband The finished end bands
The finished end bands

To finish text block:

Tie down end band knots within the text block.

Trim decorative end papers just smaller than first sheet and wet before pasting. Paste just over the fabric on the spine and press. Once pressed, trim any excess decorative papers.

Pair endband cores very slightly and paste down onto book cover.

Paste and fan out text block threads onto spine.

Boards:

Three boards are used per cover, which should be lightly wetted prior to pasting.

Boards are exactly the same size of text block in height, though not in width – Square up one corner of board and measure against cover of book, leaving a joint space at the spine, about the same size as the endbands, trim the boards to this size once pasted.

Islamic Binding trimming boards
Measuring up the board for trimming

Leave boards sharp without back cornering them.

The foredge flap will only be the thickness of one board not three, and will be done when covering the book.

The foredge envelope will be as the covers and three board thicknesses. It should be the same height for the boards and measured to exactly half the width of the boards. The point is central and the depth of the angle is half the width of the envelope.

10 Replies to “Islamic bindings – instructions part 1”

  1. Hi, I’ve awarded you the Liebster Blog! Your site’s great and has been very helpful to me and my students. Keep up the grand work!

    Kind regards,

    Roger Grech

  2. Thanks Maudie, at the fourth attempt I seem to have ‘got’ how to sew the head band! Perhaps I’m thick..but anyway your site was the most useful even better than Greenfield and Hillenbr.

    1. Thats fantastic Brenda, I’m so pleased it helped! I have a facebook page so if you fancied posting a pic of your handing and basking in some well deserved praise, please do post it up there! Headbands are notoriously difficult – especially Islamic ones!

Comments are closed.